How do I clear my engine light with OBD2?

Press the “erase/clear” button on your scanner, then turn off the key and disconnect it. Clearing any codes present will turn off your check engine light temporarily. After pressing “erase/clear” and waiting until you see a “no codes” message, you can turn off your vehicle and disconnect the scanner.

How do you clear engine codes obd2?

How to Clear OBD-II Codes

  1. Hook an OBD-II scanner to the car’s diagnostic port. This outlet is on the driver’s side, under the dash and usually near the steering wheel.
  2. Turn the scanner on.
  3. Turn the car on.
  4. Wait for the trouble code to appear on the scanner. Press the “Clear” button on the scanner to clear the code.

Can you clear a check engine light code?

Turning the Ignition On and Off

The on-off method is the equivalent fix for a vehicle’s check engine light. It forces the computer to refresh its saved state through a reboot. Simply place your key into the ignition and turn it on for 1-2 seconds, then turn it off for 1-2 seconds. Repeat this step three or four times.

Can OBD2 Scanner clear codes?

The OBD2 scanner can be used to troubleshoot automotive service codes, as well as to clear the codes. … There are many states where a vehicle can’t be registered if there is a check engine light on the dashboard, and the OBD2 scanner can clear these codes reasonably quickly.

IMPORTANT:  Question: Which manufacturers use Mercedes engines?

How long do I have to drive to reset OBD?

So why is the light still on? Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results.

How do you reset the check engine light with a gas pedal?

Fully depress the accelerator pedal and keep it for more than 10 seconds. Fully release the accelerator pedal (The CEL light will continue to blink). Turn ignition switch to On position and now you can start the car. The CEL light should be gone.

Can AutoZone clear engine codes?

AutoZone can help you diagnose the cause of the light and help you correct it. In most cases disconnecting the battery for a few minutes then reconnecting will clear the fault codes and turn off the light. But if the issue has not been resolved it will come back on, in some cases almost immediately.

How long does it take for a car computer to reset?

The readiness monitors will remain until the car has been driven long enough for the computer to evaluate the various system and sensors. The amount of time can vary based on the vehicle. In some cases it can take up to 100 miles for all of the computer monitors to completely reset.

How do you reset an ECU without disconnecting the battery?

Pulling these fuses is the equivalent of disconnecting the car battery, without all of the hassle. Leave the fuses out for at least 15 seconds. Reinstall the fuses and the fuse box cover. Your ECM should now be reset, Start your car and go for a test drive.

IMPORTANT:  Question: Where is the transmission output speed sensor located in?